Atlas Copco Water Ingress / Condensation

Moisture or water found inside generator enclosure, signs of rust on components

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Damaged door seals, Blocked enclosure drains, Incorrect installation slope, High humidity without heaters

Safety first: Isolate all power before drying or working around wet electrical components.

Dry the enclosure: Use absorbent materials and gentle heat to dry affected areas. Do not use open flames.
Inspect seals and drains: Replace worn door gaskets and clear any blocked drain holes in the base frame.
Check roof and panels: Look for gaps or damage allowing rain ingress.
Consider anti‑condensation heaters: In humid environments, install or verify operation of space heaters inside the control panel.

Medium 3/5

Enclosure Door Seal Kit

Check Price on Amazon

We may earn a commission from links on this page.