Fault Code 1436
Cummins
High Oil Temperature Shutdown
Controller shows Fault Code 1436 – Oil Temperature High (if equipped); generator shuts down
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Insufficient engine cooling, Low oil level, Faulty oil cooler or blocked passages, Failed oil temperature sensor
How to Fix / Troubleshooting
Safety first: Allow the engine to cool fully. Disable automatic start.
- Check oil level and condition: Verify oil level on the dipstick and top up if needed. If oil is old or degraded, perform an oil and filter change.
- Cooling system: Ensure coolant level is correct and radiator/fan are functioning, as poor cooling can raise oil temperature.
- Oil cooler: Inspect external oil cooler lines for kinks or blockages. Look for coolant-oil cross-contamination (milky oil) indicating cooler failure.
- Sensor check: Inspect the oil temperature sensor and wiring. Replace the sensor if readings are inconsistent with actual engine temperature.
- Reset: Clear the fault and run under moderate load while monitoring temperatures.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Oil Temperature Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements