DuroStar
Display/Control Panel Failure
Control panel display is blank or unreadable, but generator may still run manually.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blown display fuse, Failed LCD/LED module, Loose ribbon cable, Control board power supply fault
How to Fix / Troubleshooting
Safety first: Turn OFF the generator and disconnect the battery before opening the control panel.
- Check panel fuse: Locate and test the low‑voltage fuse feeding the display. Replace if blown.
- Inspect connectors: Reseat the ribbon cable and connectors between the display and main control board.
- Measure panel voltage: Verify that the control board supplies the correct DC voltage to the display connector. If absent, the board may be faulty.
- Replace display module: If power is present but the screen remains blank or garbled, replace the DuroStar display/control panel assembly.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Control Panel Display Module
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements