Einhell
Display / Control Panel Power Failure
Control panel display is blank, but engine can still be started manually (if equipped with recoil)
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blown panel fuse, Loose display connector, Failed LCD/LED display module, Faulty DC regulator for control electronics
How to Fix / Troubleshooting
Safety first: Turn OFF the generator and disconnect the battery before opening the control panel.
- Check panel fuse: Locate the low‑voltage fuse feeding the display and controller. Replace if blown.
- Inspect connectors: Reseat the ribbon cable or plug between the display and main control board.
- Measure panel supply: Using a multimeter, verify that the correct DC voltage is present at the display connector when the ignition is ON.
If supply is present but the display remains blank, replace the Einhell display module or entire control panel assembly.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Einhell Generator Display Module
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements