Controller shows 'Low Oil' or 'Add Oil' and prevents start; oil level is near or below minimum on dipstick.

Safety: Ensure the generator cannot start automatically. Allow the engine to cool before checking oil.

• Verify level and add oil: Check the dipstick on level ground. Add the correct grade of oil slowly, rechecking until the level is at the full mark. Do not overfill.
• Inspect for leaks: Examine the base pan, under the engine, and around the oil filter and drain for wet oil. Repair or replace leaking components (filter, drain plug gasket, crank seals).
• Check unit leveling: Confirm the generator pad is level. If the unit is significantly tilted, correct the installation to ensure accurate oil level sensing.
• Monitor consumption: After topping off, log oil level over several test runs. Excessive consumption indicates internal engine wear and may require professional service.