Honeywell
Control panel power or display failure
Controller display is blank or unreadable
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blown control fuse, Failed controller display module, Loose ribbon cable or harness, No DC power from battery
How to Fix / Troubleshooting
Safety first: Turn OFF the generator and disconnect battery negative before removing the controller panel.
Steps:
- Check battery voltage: Verify the starting battery has proper voltage. Restore or replace if dead.
- Inspect fuses: Locate and test the low-voltage control fuses on the Honeywell controller. Replace any blown fuses with the correct rating.
- Check connectors: Reseat the ribbon cable and harness connectors on the back of the display/controller.
- Controller replacement: If power and fuses are good but the display remains blank or garbled, replace the controller/display module with the correct Honeywell part.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Generator Controller
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements