F30
Amana
Dispenser or Load Sensor Error (model-dependent)
Washer-dryer combo displays F30 and may not sense load or balance correctly.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed dispenser motor, Jammed dispenser drawer, Faulty load/balance sensor, Wiring issues to sensor
How to Fix / Troubleshooting
Safety first: Disconnect power before accessing internal components.
- Check dispenser movement: If your model has a motorized dispenser, remove the top panel and observe whether the dispenser motor turns during diagnostics. Clear any obstructions.
- Inspect drawer: Remove and clean the dispenser drawer and housing. Ensure it slides freely.
- Check sensor wiring: For models using a load or balance sensor, inspect the harness and connector at the sensor and control board.
- Replace faulty component: If the dispenser motor or sensor tests out of spec per the service manual, replace the defective part.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Dispenser Motor Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements