Washer-dryer combo displays F33 and may not start or may stop mid-cycle.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Water leak detected at base, Failed recirculation or drain pump, Loose pump wiring, Faulty leak sensor (if equipped)

Safety first: Unplug the unit and turn off water supply.

Check for leaks: Remove the lower front panel and inspect the base pan for water. If water is present, locate and repair the leak (hoses, tub seal, pump housing).
Dry the base: Use towels or a wet/dry vacuum to remove water from the base. Allow sensors to dry completely.
Inspect pumps: Check the drain pump and any recirculation pump for leaks, cracks, or loose clamps.
Test pump motors: Use a multimeter to test pump windings for continuity. Replace any failed pump.

Hard 4/5

Drain Pump Assembly

Check Price on Amazon

We may earn a commission from links on this page.