Washer-dryer combo displays F35 and may not fill or may abort cycles.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Failed analog pressure sensor, Blocked pressure hose, Moisture in sensor connector, Control misreading sensor voltage

Safety first: Unplug the unit and shut off water.

Inspect hose: Check the small hose from the tub to the analog pressure sensor for blockages or damage. Clear or replace as needed.
Dry connections: Ensure the sensor connector is dry and free of corrosion.
Test sensor: Follow the service manual to measure sensor output voltage at different water levels. Replace the sensor if readings are incorrect.
Control board: If sensor and hose are good, the main control may be faulty.

Hard 4/5

Analog Pressure Sensor

Check Price on Amazon

We may earn a commission from links on this page.