Washer-dryer combo displays F36 and may not start.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Open lock motor, Failed lock switch, Wiring harness damage, Control lock circuit failure

Safety first: Disconnect power.

Access lock: Remove front panel or boot clamp to reach the door lock assembly.
Test motor and switches: Use a multimeter to check continuity of the lock motor and internal switches. Replace the lock if defective.
Inspect harness: Check wiring from lock to control for continuity and damage.
Replace control: If lock and wiring are good, the control board may need replacement.

Medium 3/5

Door Lock Assembly

Check Price on Amazon

We may earn a commission from links on this page.