E32
Amica
Pressure Sensor Calibration / Range Fault
Washer-dryer intermittently overfills or underfills; E32 displayed
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Incorrect pressure sensor output, Air leaks in pressure hose, Control board miscalibration, Sensor not seated correctly
How to Fix / Troubleshooting
Safety first: Unplug the appliance.
- Check for air leaks: Inspect the entire length of the pressure hose for pinholes, splits, or loose connections. Replace if any damage is found.
- Ensure proper routing: The hose should rise smoothly without sharp bends or low spots that can trap water.
- Replace sensor if unstable: If E32 appears intermittently and other causes are excluded, replace the pressure sensor.
- Service calibration: Some models require a service-mode calibration after sensor replacement; refer to Amica service documentation or have a technician perform this step.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Electronic Pressure Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements