Water overheats; very hot wash or steam from door; E62 displayed

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Shorted heater relay on PCB, Faulty NTC sensor reading too low, Wiring short causing continuous heating

Safety first: Unplug the appliance immediately. Risk of scalding and damage to fabrics.

Test NTC: Check the temperature sensor for correct resistance. Replace if readings are too low or unstable.
Inspect PCB: Look for a welded heater relay or burnt components. Replace the control board if the relay is stuck closed.
Do not use the machine until the overheating fault is fully resolved.

Professional Required 5/5

NTC Temperature Sensor

Check Price on Amazon

We may earn a commission from links on this page.