Washer-dryer combo shows E60; typically associated with heating system faults (wash or dry).

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Open heating element, Tripped thermal cutout, Faulty NTC sensor, Heater relay failure on control board

Safety: Unplug the appliance; heaters operate at mains voltage.

Determine which heater: Note whether the error occurs during washing (water heating) or drying (air heating).
Test relevant heater: Access the tub heater or dryer heater and measure resistance. Replace if open.
Check thermostats and NTC: Test safety thermostats and temperature sensors for continuity and correct resistance.

If heaters and sensors are good, the control board heater circuit is likely faulty and should be serviced by a technician.

Hard 4/5

Dryer Heating Element Assembly

Check Price on Amazon

We may earn a commission from links on this page.