Asko
User Interface / Control Lock or Program Logic Fault
Washer-dryer combo powers on but will not start any cycle; Start button unresponsive, no error code.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Child lock (control lock) enabled, Faulty Start/Pause button, Defective user interface PCB, Communication issue between UI and main control
How to Fix / Troubleshooting
Safety: Unplug the unit before removing the control panel.
- Check child lock: Refer to the Asko manual for the key combination to toggle the control lock (often holding specific buttons for several seconds). Disable it and try again.
- Reset program: Turn the program selector to Off, wait 30 seconds, then select a simple cycle and press Start.
- Inspect UI panel: Remove the top and front control panel to access the user interface board. Check for loose ribbon cables or connectors.
- Test Start button: With a multimeter, test the Start/Pause switch for continuity when pressed. Replace the UI board if the switch is defective or if there is visible board damage.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
User Interface Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements