Washer-dryer combo shows E19; unit may stop during heating or show erratic temperature behavior.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Failed wash heater element, Open temperature sensor in wash circuit, Faulty heater relay on control board, Limescale buildup on heater

Safety first: Disconnect power and allow the unit to cool before servicing the heater.

Check for hot wash function: Run a hot wash cycle and see if the water warms. If not, suspect the internal heater.
Access heater: On many Avanti combos, the wash heater is mounted in the lower front or rear of the tub. Remove the appropriate panel to access it.
Test heater element: Use a multimeter to check continuity of the heater. Replace if open or shorted.
Inspect wiring and sensor: Verify secure connections to the heater and associated temperature sensor.

Hard 4/5

Wash Heater Element

Check Price on Amazon

We may earn a commission from links on this page.