Avanti
Overheating Component or Friction
Washer-dryer combo emits a burning smell during wash or dry cycles.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Drive belt slipping on pulley, Lint buildup on heater element, Foreign object stuck between drum and tub, Electrical short in motor or wiring
How to Fix / Troubleshooting
Safety first: Immediately stop the cycle, unplug the unit, and do not continue using it until the source is identified.
- Inspect belt and pulleys: Remove the rear panel and check for belt dust or signs of overheating. Replace a glazed or burnt belt.
- Clean heater area: Access the dryer heater housing and remove lint and debris that may be scorching.
- Check for drum obstructions: Look around the door seal and drum edges for items rubbing and causing friction.
- Electrical inspection: Smell near the motor and control board for burnt odor. If wiring or components appear burnt, contact a technician for repair.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements