Avanti
Insufficient Spin Extraction
Washer-dryer combo leaves clothes very wet at the end of cycle, even though it appears to spin.
Advertisements
Possible Causes
Spin speed set too low, Out-of-balance load causing reduced spin, Clogged drain system slowing water removal, Worn drive belt slipping under load
How to Fix / Troubleshooting
Safety first: Unplug the unit before internal inspection.
- Check settings: Ensure the selected program uses high spin speed and that any "low spin" or "delicate" options are not enabled.
- Redistribute load: Open the door, rearrange items, and run an additional spin-only cycle.
- Verify drainage: Confirm that water is pumping out quickly during spin. If not, clean the pump and hoses.
- Inspect belt: Check the drive belt for wear or looseness and replace if slipping.
Advertisements
Repair Difficulty
Easy
2/5
Advertisements