E16
Beko Inlet Valve Electrical Fault

Washer-dryer displays water inlet error; no water enters despite tap being open

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Burnt or open-circuit inlet valve coil, Loose inlet valve connector, Broken wiring to inlet valve, PCB output failure to valve

How to Fix / Troubleshooting

Safety first: Unplug the appliance and close the water tap before servicing.

  • Step 1 – Confirm water supply: Ensure water pressure is adequate and hose filters are clean (see E02).
  • Step 2 – Test inlet valve coil: Access the inlet valve from the top. Disconnect the electrical connector and measure resistance across the coil. An open circuit indicates a failed valve that must be replaced.
  • Step 3 – Inspect connector and wiring: Check for signs of overheating or corrosion at the valve connector. Repair or replace damaged connectors and wiring.
  • Step 4 – PCB output check: If the valve coil is good, a technician can test whether the PCB is supplying voltage to the valve during fill. Lack of output suggests a PCB fault.
Advertisements

Repair Difficulty

Medium 3/5

Required Part

Water Inlet Valve
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements