E17
Beko Door Lock Circuit Fault

Washer-dryer shows door lock error shortly after starting; drum does not move

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Open-circuit door lock coil, Damaged door lock connector, Broken wiring between lock and PCB, PCB door lock driver failure

How to Fix / Troubleshooting

Safety first: Disconnect mains power before removing the door seal or lock.

  • Step 1 – Reseat door lock connector: Access the door lock by removing the door seal clamp. Disconnect and reconnect the wiring plug to ensure good contact.
  • Step 2 – Test lock coil: With the connector removed, measure resistance across the lock coil terminals. An open circuit indicates a failed lock that must be replaced.
  • Step 3 – Inspect wiring: Follow the harness from the lock to the PCB, checking for breaks or crushed sections. Repair as needed.
  • Step 4 – PCB diagnosis: If the lock and wiring are good but E17 persists, the PCB may not be energizing the lock and should be checked by a professional.
Advertisements

Repair Difficulty

Medium 3/5

Required Part

Door Lock Assembly
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements