E07
Belling
Motor Drive / Triac Fault
Washer-dryer fails to spin or shows E07; drum may attempt to turn then stop.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Shorted motor windings, Shorted motor triac on PCB, Damaged motor harness, Overloaded drum causing motor stall
How to Fix / Troubleshooting
Safety: Unplug the machine before any internal inspection.
- Reduce load: Remove some items and try a spin-only cycle. Overloading can trigger motor protection and error codes.
- Inspect motor and belt: Remove the rear panel and check that the drive belt is intact and correctly tensioned on the motor pulley and drum pulley. Replace if broken or badly worn.
- Check harness: Examine the wiring from the motor to the main PCB for chafing against the drum or cabinet. Repair or replace damaged sections.
- Test motor windings: With power off, measure resistance of the motor windings according to the Belling service manual. If windings are shorted or significantly out of spec, replace the motor.
- PCB triac/driver: If the motor and wiring are sound but the motor never receives drive voltage, the PCB motor triac or driver IC may have failed. This is a complex repair; replacement of the PCB is recommended via a qualified engineer.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control PCB
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements