E19
Belling Configuration / EEPROM Fault

Washer-dryer shows E19; may be associated with EEPROM or configuration memory issues.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Corrupted EEPROM on main PCB, Incorrect PCB for model, Failed firmware update (if applicable), Electrical surge damage

How to Fix / Troubleshooting

Safety: Disconnect mains power before handling the control board.

  • Power reset: Unplug for 10–15 minutes and reconnect. Occasionally, transient memory errors clear after a full power-down.
  • Model check: If the PCB was recently replaced, confirm that the correct Belling part number and configuration for your washer-dryer combo model was installed.
  • Factory reset: Some models support a service or factory reset via a button combination (consult Belling service documentation). Perform this only if documented for your model.
  • PCB replacement: Persistent E19 usually indicates a faulty EEPROM or corrupted firmware. The main PCB will need replacement and possibly programming by an authorised service centre.
Advertisements

Repair Difficulty

Professional Required 5/5

Required Part

Main Control PCB
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements