Belling
Program Stalling / Sensor Feedback Issue
Washer-dryer stops mid-cycle and does not progress, but display remains on and no code is shown.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Faulty water level pressure switch, Heater not reaching temperature, Motor not achieving required speed, Control PCB logic fault
How to Fix / Troubleshooting
Safety: Disconnect power before internal diagnostics.
- Note stage: Identify whether the stall occurs during fill, heat, wash, drain, or spin. This points to the suspect system.
- Check fill and drain: Ensure the machine fills and drains correctly by observing water level and pump operation.
- Heating check: If stalling during heating, test the wash heater and NTC sensor.
- Spin check: If stalling before spin, investigate motor and balance issues.
- Pressure switch: Clean and test the pressure switch and hose to ensure accurate water level feedback.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Water Level Pressure Switch
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements