E19
Blomberg
Control Board Memory / Configuration Fault
Washer-dryer displays E19; EEPROM or configuration error
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corrupted EEPROM data on main PCB, Incorrect or failed software update, Faulty main control board, Power surge damage
How to Fix / Troubleshooting
Safety first: Unplug the appliance before accessing electronics.
- Power cycle: Disconnect power for at least 10 minutes to allow full reset, then reconnect and test.
- Check supply quality: Ensure the washer-dryer is connected to a stable mains supply and avoid using undersized extension cords.
- Factory reset (if available): Consult the user manual for any key combination that performs a factory reset of settings.
- Board reprogramming/replacement: If E19 persists, the main PCB may require reprogramming with the correct Blomberg firmware or replacement. This must be done by an authorized service technician with the proper tools.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Main Control Board (PCB)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements