Blomberg
Drum Support / Spider Arm Failure
Washer-dryer drum has visible play and scrapes against door seal
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Corroded or broken drum spider (support arm), Severe bearing wear, Overloading causing structural fatigue
How to Fix / Troubleshooting
Safety first: Unplug the appliance. This is a major mechanical fault.
- Check drum movement: Push the drum up and down at the front. Excessive movement or scraping indicates internal support failure.
- Inspect through rear: Remove the rear panel and check for misalignment of the drum pulley and tub.
- Do not continue use: Operating with a broken spider can cause catastrophic damage and leaks.
- Professional repair: Drum spider replacement usually requires full tub removal and is best done by a qualified technician. In some cases, replacing the entire drum/tub assembly is more economical.
Advertisements
Repair Difficulty
Professional Required
5/5
Required Part
Drum Spider Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements