Brandt
No Power / Power Supply Fault
Washer-dryer combo will not power on; no lights or display.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blown mains fuse or tripped breaker, Faulty power cord, Defective mains filter (EMI filter), Failed main control board power supply section
How to Fix / Troubleshooting
Safety first: Disconnect the appliance from the mains before any internal checks. If you are not comfortable working with mains voltage, contact a professional.
- Check outlet and breaker: Test the wall outlet with another device. Reset any tripped breaker or replace a blown fuse as appropriate.
- Inspect power cord: Look for cuts, burns, or kinks. Replace the cord if damaged.
- Check mains filter: Remove the rear or top panel to locate the mains filter where the power cord enters. Inspect for burnt components. Replace the filter if damaged.
- Control board power: If the mains filter is good, the main control board may not be generating low-voltage power. Board replacement is usually required.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements