Café
Overheating Component or Belt Slippage
Washer-dryer combo emits a burning rubber or electrical smell during operation.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Slipping drive belt, Lint buildup on heater, Failing motor, Electrical short on control or wiring
How to Fix / Troubleshooting
Safety first: Immediately stop the cycle, unplug the unit, and do not continue using it until the source is identified.
Steps:
- Inspect belt: Remove the rear panel and check the drive belt for glazing, cracks, or signs of melting. Replace if damaged.
- Clean heater area: Inspect the dryer heater housing for lint buildup and carefully vacuum it out.
- Check for scorch marks: Look for burned connectors or wiring insulation around the motor and control board.
When to call a technician: Any persistent burning smell or visible electrical damage requires immediate professional service.
Advertisements
Repair Difficulty
Hard
4/5
Advertisements