E42
Electrolux
Door Unlock Fault
Washer-dryer combo door will not unlock at end of cycle; E42 may be displayed.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Stuck door lock solenoid, Faulty door lock assembly, Control board not sending unlock signal, Wiring issue to door lock
How to Fix / Troubleshooting
Safety: Unplug the appliance. Do not force the door open with tools as this can damage the lock and door.
- 1. Wait and power cycle: Allow several minutes after the cycle ends. Then unplug for 1–2 minutes and plug back in to see if the lock releases.
- 2. Manual release: Many Electrolux combos have a manual release tab near the door lock accessible by removing the lower front panel or pulling back the door boot. Pull the tab gently to open the door.
- 3. Replace lock: If the lock repeatedly fails to release, replace the door lock assembly.
If the lock tests good but E42 persists, the main control board may be faulty and require professional diagnosis.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Door Lock Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements