E60
Electrolux
General Drying Heater / Heating System Fault
Washer-dryer combo has drying problems (no heat or overheating); E60 displayed as a general heating error.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed dryer heating element, Open thermal fuse or thermostat, Blocked condenser or airflow path, Faulty heater relay on control board
How to Fix / Troubleshooting
Safety: Unplug the unit. Heating components can remain hot after use.
- 1. Clean lint and condenser: Remove and clean the condenser unit (if user-removable) and any accessible lint filters. Ensure airflow paths are clear.
- 2. Check rear and internal vents: Make sure the combo has adequate ventilation and that any exhaust paths (if vented) are not blocked.
- 3. Inspect heater circuit: Access the dryer heater assembly (often at the rear or side). Check wiring and thermostats for obvious damage.
If cleaning does not resolve the issue, the heater element, thermostats, or control board may need testing and replacement by a technician.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Dryer Heating Element Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements