Washer-dryer combo does not reach target drying temperature; clothes remain damp; E61 displayed.

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Partially failed heating element, High-limit thermostat opening prematurely, Restricted airflow through condenser, Faulty NTC temperature sensor in dryer circuit

How to Fix / Troubleshooting

Safety: Disconnect power.

1. Clean condenser and filters: Thoroughly clean the condenser unit and all lint filters. Rinse the condenser under running water if the manual allows.
2. Check load size: Avoid overloading the combo in drying mode; this can cause poor drying and E61.
3. Inspect NTC sensor: Locate the dryer temperature sensor (NTC) near the heater or air duct. Ensure it is clean and firmly attached.

If E61 persists, the heater element, thermostats, or NTC sensor may require electrical testing and replacement.

Repair Difficulty

Medium 3/5

Required Part

Dryer NTC Temperature Sensor

Check Price on Amazon

We may earn a commission from links on this page.