Washer-dryer combo shows E70; temperature sensing issues in wash or dry cycles.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Open or shorted NTC sensor, Loose NTC connector, Damaged wiring harness, Faulty control board analog input

Safety: Unplug the unit.

1. Identify which NTC: Depending on the subcode, the fault may be in the wash tub NTC or dryer NTC. Refer to the service manual if available.
2. Test NTC: Disconnect the sensor and measure its resistance at room temperature. Compare to Electrolux specifications. Replace if out of range.
3. Check connectors: Reseat the NTC connectors at both the sensor and control board.

If a new NTC does not clear E70, the control board may be defective.

Medium 3/5

NTC Temperature Sensor

Check Price on Amazon

We may earn a commission from links on this page.