E10
Equator Main Control Board Communication / Internal Fault

Washer-dryer combo shows E10 and will not start; control panel may be unresponsive or erratic.

Advertisements

Safety Warning

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Advertisements

Possible Causes

Failed main PCB in Equator combo, Loose wiring harness between control panel and main board, Power surge damage, Corrupted control firmware

How to Fix / Troubleshooting

Safety first: Disconnect power for several minutes before attempting any reset or inspection.

  • Power reset: Unplug the unit for at least 5 minutes to allow capacitors to discharge. Plug back in and try to start a simple cycle.
  • Check outlet: Verify the wall outlet voltage is correct and stable using a multimeter or by plugging in another appliance.
  • Inspect wiring: Remove the top panel and inspect the wiring harness connections to the main control board and user interface board. Reseat any loose connectors.
  • Look for damage: Examine the control board for burnt components, scorch marks, or corrosion. Any visible damage usually means the board must be replaced.

If E10 persists after reseating connectors and power reset, replacement of the main control board is typically required and is best handled by a qualified technician.

Advertisements

Repair Difficulty

Professional Required 5/5

Required Part

Main Control Board (PCB)
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements