Washer-dryer combo displays E19; often associated with internal memory or configuration error.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Corrupted EEPROM on Equator main board, Power surge during operation, Incorrect control board replacement, Firmware error

Safety first: Disconnect power before any inspection.

Power reset: Unplug the unit for 10 minutes and reconnect to see if the error clears.
Check model configuration: If the control board was recently replaced, verify that the correct Equator washer-dryer combo board and configuration jumpers/settings were used.

EEPROM or firmware faults generally require control board replacement or reprogramming by an authorized Equator service provider.

Professional Required 5/5

Main Control Board (PCB)

Check Price on Amazon

We may earn a commission from links on this page.