Drying cycle stops prematurely and laundry is still wet.

Safety first: Unplug the appliance before cleaning sensor bars.

• Step 1 – Clean sensor bars: Locate the metal moisture sensor strips inside the drum (usually near the door). Clean them with a soft cloth and mild detergent to remove any waxy softener film.
• Step 2 – Check wiring: Access the rear of the sensor bars and ensure the wires are firmly connected and not broken.
• Step 3 – Program selection: Use appropriate drying programs for the load type and size. Very small loads may not contact the sensors properly.
• Step 4 – Control board: If issues persist, the Fagor control board’s moisture sensing circuit may require professional diagnosis.