E16
Fagor
Communication Error (Main PCB to Interface)
Washer-dryer shows E16 and may not start; often associated with communication issues between boards.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Loose or oxidized connector between display board and main PCB, Damaged communication cable, Faulty user interface board, Faulty main control board
How to Fix / Troubleshooting
Safety first: Unplug the appliance before removing the control panel.
- Step 1 – Access control boards: Remove the top cover and the front control panel as needed to expose the user interface (display) board and main control board.
- Step 2 – Reseat connectors: Disconnect and reconnect the ribbon cable or harness between the boards several times to clean contacts. Ensure connectors are fully seated and latched.
- Step 3 – Inspect cables: Look for kinks, cuts, or burn marks on the communication cable. Replace if damaged.
- Step 4 – Board substitution: If possible, test with a known-good interface board or main PCB. If E16 disappears when one board is changed, replace the faulty board.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Main Control Board (PCB)
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements