Washer-dryer stops mid-cycle with E10; water level appears too low or too high relative to program.

Safety first: Disconnect power and close water taps before opening the cabinet.

• 1. Inspect pressure hose: Remove the top cover and locate the pressure sensor and its hose. Check for splits, hardening, or disconnection at either end. Replace if damaged.
• 2. Clear blockages: Detach the hose from the sensor and blow gently through it toward the tub to clear soap scum or lint. Ensure the tub connection is not blocked.
• 3. Check sensor connection: Reseat the electrical connector on the pressure sensor. Look for corrosion or bent pins.
• 4. Replace sensor if suspect: If the hose is sound but E10 persists, replace the pressure sensor with a compatible Gaggenau part.
• 5. Control module check: If a new sensor does not resolve the issue, the control module may be misinterpreting the signal and should be tested or replaced by a professional.