E16
Gaggenau
Door Lock Monitoring Error
Washer-dryer shows E16; door may open during cycle or cannot be locked reliably.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Intermittent door lock contacts, Loose door lock wiring, Misaligned door hinge causing poor latch engagement, Faulty control module door lock circuit
How to Fix / Troubleshooting
Safety first: Unplug the appliance. A faulty door lock can cause water leaks and safety hazards.
- 1. Check door alignment: Inspect the door for sagging or misalignment. Tighten hinge screws and adjust the door so it closes squarely against the seal.
- 2. Inspect door lock: Access the door lock behind the front panel. Look for signs of wear or intermittent contact (e.g., discoloration, loose internal parts). Replace if suspect.
- 3. Secure wiring: Ensure the door lock connector is tight and that wires are not strained when the door is opened/closed.
- 4. Test operation: After reassembly, run a short cycle and gently press on the door to see if E16 reappears. If the error persists with a new lock and good alignment, the control module may require replacement.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Door Lock Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements