Washer-dryer leaves clothes very wet at the end of the cycle, but no error code is shown.

Safety first: Unplug the appliance before cleaning the filter.

• 1. Clean drain filter: Open the lower service flap, drain residual water, and remove and clean the pump filter thoroughly.
• 2. Check drain hose: Ensure the hose is not kinked and is free of blockages.
• 3. Redistribute load: Run a spin-only cycle with the load redistributed evenly. Avoid mixing heavy and light items.
• 4. Inspect motor performance: If the drum struggles to accelerate or makes sparking noises (on brushed motors), inspect and replace worn carbon brushes.
• 5. Verify spin settings: Ensure the selected program has maximum spin enabled and that any low-spin or delicate options are not active.