E82
GE
Internal Electronics Overheat / Control Board Overtemperature
Washer-dryer combo shows E82 and may shut down unexpectedly or trip internal thermal protection.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blocked control board ventilation, Failed internal cooling fan, High ambient temperature around unit, Defective temperature sensor on control board
How to Fix / Troubleshooting
Safety first: Disconnect power before removing the top or rear panels.
- Improve ventilation: Ensure the combo has adequate clearance on all sides per GE installation instructions. Do not enclose it tightly in a cabinet without proper venting.
- Clean dust and lint: Remove the top panel and gently vacuum dust from the main control board area, paying attention to any heat sinks or vents.
- Check internal fan (if present): Some models have a small fan to cool the electronics. Confirm it spins freely and runs during operation. Replace the GE control cooling fan if it is seized or silent.
- Ambient temperature: Avoid operating the unit in very hot rooms or closets without ventilation, as this can trigger E82.
- Control board sensor: If cooling and ventilation are adequate but E82 persists, the temperature sensor on the control board may be faulty, requiring replacement of the GE main control board.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
GE Main Control Board
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements