GE Door Stuck Locked

Washer-dryer combo door will not unlock at the end of the cycle; clothes are trapped inside.

Advertisements

Possible Causes

Door lock mechanism jammed, Control not receiving end-of-cycle signal, Water still detected in tub, Faulty door lock assembly

How to Fix / Troubleshooting

Safety first: Unplug the unit before attempting manual release. Beware of hot water or surfaces.

  • Wait a few minutes: Some models delay unlocking for safety. Wait 2–5 minutes after cycle end.
  • Check for water: If water is visible in the drum, run a drain/spin cycle. If it will not drain, clean the drain pump filter.
  • Manual release: Many GE combos have a manual door lock release accessible through the lower front panel or behind the gasket. Pull the release tab to open the door.
  • Replace lock: If the problem recurs, replace the GE door lock assembly.
Advertisements

Repair Difficulty

Easy 2/5

Required Part

GE Door Lock Assembly
Check Price on Amazon

We may earn a commission from links on this page.

Advertisements