Washer-dryer will not fill with water, cycle stops shortly after start and E1 is displayed.

Safety first: Unplug the appliance and close the water supply taps before working on hoses or valves.

• Check household water supply: Ensure both hot and cold taps feeding the washer-dryer are fully open and that there is normal water pressure at the faucet.
• Clean inlet filters: Turn off water, unscrew the inlet hoses from the back of the Gorenje combo. Inside the valve ports you will see small mesh filters. Gently pull them out with needle-nose pliers, rinse under running water, and remove any debris. Reinstall filters and hoses securely.
• Inspect inlet hoses: Check for kinks, crushing, or internal blockage. Replace damaged hoses.
• Test a quick cycle: Restore water and power, run a rinse or quick wash. If E1 persists, the inlet valve coil may be faulty.
• Check inlet valve electrically (advanced): With power disconnected, remove the top cover, locate the water inlet valve assembly, and test coil resistance with a multimeter. Open or shorted coils indicate a bad valve that should be replaced with a compatible Gorenje inlet valve.

If you are not comfortable using a multimeter or removing panels, contact a qualified technician.