E10
Gorenje
General Water Supply / Level Error
Washer-dryer shows E10 and will not start or stops; often related to water inlet or level issues.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Partially blocked inlet valve filters, Intermittent water supply pressure, Partially blocked pressure hose, Faulty pressure switch
How to Fix / Troubleshooting
Safety first: Unplug the appliance and close water taps before disconnecting hoses.
- Verify water flow: Disconnect the inlet hose from the machine and briefly open the tap into a bucket to confirm strong flow.
- Clean inlet filters: Remove and rinse the mesh filters in the Gorenje inlet valve ports.
- Check detergent use: Excessive suds can interfere with level sensing. Use only HE detergent and correct dosage.
- Advanced checks: If the error persists, inspect the pressure hose and sensor as described for E3. Replace the pressure switch if it gives inconsistent readings.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Water Level Pressure Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements