Washer-dryer displays E41; door appears closed but machine still reports door error.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Faulty door lock switch contacts, Loose wiring between door lock and control board, Defective control board input circuit

Safety first: Unplug the appliance before accessing the door lock wiring.

Check door closure again: Confirm the door is fully latched and not flexing when pressed.
Access door lock: Remove the front part of the door seal and unscrew the lock. Inspect the connector for looseness or corrosion.
Reseat connector: Disconnect and reconnect the plug several times to clean contacts. Ensure it is firmly locked in place.
Replace lock if needed: If the error persists, replace the door lock assembly with a Gorenje-compatible part.

Medium 3/5

Door Lock Assembly

Check Price on Amazon

We may earn a commission from links on this page.