E51
Gorenje
Motor Triac Short / Motor Drive Short Circuit
Washer-dryer displays E51; often appears immediately when trying to start a cycle.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Shorted motor windings, Shorted triac or power device on control board, Damaged motor harness causing short to chassis
How to Fix / Troubleshooting
Safety first: Unplug the appliance. This error involves high-voltage components; exercise caution.
- Visual inspection: Remove rear panel and inspect motor and wiring for burn marks, melted insulation, or signs of arcing.
- Check harness routing: Ensure the motor harness is not rubbing against the drum or frame causing insulation damage.
- Test motor (advanced): Use a multimeter to check for continuity between motor terminals and ground. Any short to chassis indicates a bad motor that must be replaced.
Control board triac failures require board repair or replacement by a qualified technician.
Advertisements
Repair Difficulty
Professional Required
5/5
Advertisements