Washer-dryer shows E62; water overheats or there is a risk of boiling.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Shorted heater relay on control board, Faulty NTC sensor reading too low, Wiring short causing heater to be energized continuously

Safety first: Unplug the appliance immediately if you suspect overheating. Do not touch hot metal parts.

Allow to cool: Let the machine cool completely before inspection.
Test NTC sensor: Check for correct resistance; replace if reading is too low or unstable.
Inspect wiring: Look for signs of melted insulation or short circuits near the heater.

Overheating due to a stuck relay is dangerous; control board repair or replacement should be performed by a professional.

Professional Required 5/5

NTC Temperature Sensor

Check Price on Amazon

We may earn a commission from links on this page.