Hotpoint
No mains power or failed power supply circuit
Washer-dryer combo will not power on at all; no lights or display.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Blown mains fuse, Faulty power switch, Failed mains filter (interference suppressor), Faulty main control board power supply
How to Fix / Troubleshooting
Safety: Ensure the appliance is unplugged before opening any covers. Mains voltages are lethal.
- Check outlet and fuse: Test the wall socket with another appliance. Check and replace the plug fuse with the correct rating if blown.
- Inspect mains cable: Look for cuts or damage along the power cord. Replace if compromised.
- Check mains filter: Remove the top or rear panel to access the mains filter module where the power cord enters. Look for burn marks or bulging components. Replace the filter if damaged.
- Power switch and PCB: Verify the on/off switch (if fitted) operates correctly. If power reaches the PCB but there is no response, the board's low-voltage power supply may have failed and the PCB will need replacement.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Mains Filter / Interference Suppressor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements