Washer-dryer does not fill with water or fills very slowly; H20 displayed on some digital Indesit models.

Safety: Turn off water supply and unplug before disconnecting hoses.

• Check taps: Ensure the water tap feeding the washer-dryer is fully open and water pressure is adequate.
• Clean inlet filters: Turn off the tap, disconnect the inlet hose from the machine, and remove the small mesh filter in the valve. Rinse under running water to remove grit.
• Inspect hose: Check for kinks or crushing along the hose length. Replace if damaged.
• Test inlet valve: With the machine unplugged, inspect the valve coil connectors. If you have a multimeter, measure coil resistance (typically 2–5 kΩ). An open coil indicates a failed valve that must be replaced.