Indesit Intermittent Control or Sensor Fault

Washer-dryer stops mid-cycle and will not continue; some lights may flash but no error code is shown.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Loose wiring connection, intermittent door lock, overheating control board, partially blocked pump or pressure system

Safety: Unplug before internal inspection.

Note when it stops: Observe whether it stops during fill, wash, drain, or spin to narrow down the subsystem.
Check door lock: Wiggle the door gently; if the machine restarts or stops, the lock may be intermittent. Replace the door lock.
Inspect connectors: Reseat all major connectors on the main PCB, motor, pump, and sensors.
Clean pump and pressure system: Ensure the pump filter, hoses, and pressure switch hose are clear.

Medium 3/5

Door Lock Assembly / Wiring Harness

Check Price on Amazon

We may earn a commission from links on this page.