F13
Kenmore
Dryer Door / Dispenser or Vent Thermostat Error (model-dependent)
Washer-dryer combo will not start drying cycle or stops drying and displays F13.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Faulty dryer door switch, failed exhaust thermostat, wiring issue to dryer components, control board sensing error
How to Fix / Troubleshooting
Safety first: Unplug the combo and allow any hot components to cool before working.
- Check door switch: Open and close the main door firmly. Listen for a distinct click from the door switch. If the door feels loose or the latch is worn, inspect the door lock/switch assembly behind the front panel.
- Test continuity: Remove the front panel (if accessible) and test the door switch with a multimeter. Replace if it does not show continuity when the door is closed.
- Inspect dryer thermostats: Access the rear panel and locate the exhaust thermostat or thermal limiter on the blower housing or exhaust duct. Check for continuity. A blown thermostat or thermal fuse will interrupt the drying circuit.
- Clean lint path: Excess lint can overheat the dryer section and trip thermostats. Clean the internal lint duct, blower wheel, and external vent hose thoroughly.
Advertisements
Repair Difficulty
Hard
4/5
Required Part
Door Lock / Switch Assembly
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements