F35
Kenmore
Analog Pressure Sensor Error
Washer-dryer combo displays F35 and may not fill or may abort cycles early.
Advertisements
Safety Warning
This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.
If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.
Advertisements
Possible Causes
Failed analog pressure sensor, blocked pressure hose, control board misreading sensor signal, moisture in sensor connector
How to Fix / Troubleshooting
Safety first: Unplug the unit and shut off water supply.
- Locate analog pressure sensor: Remove the top panel. The sensor is a small electronic module connected to a thin hose and a wiring harness.
- Inspect hose: Remove the hose from the sensor and blow through it to clear any blockage. Check for cracks or kinks and replace if damaged.
- Check connector: Unplug and replug the electrical connector to the sensor. Look for moisture or corrosion and dry/clean as needed.
- Replace sensor: If F35 persists after hose and connector checks, replace the analog pressure sensor with the correct Kenmore part.
Advertisements
Repair Difficulty
Medium
3/5
Required Part
Analog Pressure Sensor
Check Price on Amazon
We may earn a commission from links on this page.
Advertisements