Washer-dryer combo displays HE during drying; clothes remain damp or cycle stops early.

This repair may involve working with high voltage components or water connections. Always unplug the appliance before removing any panels.

If you are not confident in your ability to perform this repair safely, we strongly recommend contacting a professional technician.

Possible Causes

Failed dryer heating element, blown thermal fuse, open high-limit thermostat, restricted exhaust duct

Safety first: Unplug the combo and allow it to cool completely before working on the dryer section.

Clean exhaust path: Disconnect and clean the external vent hose and wall vent. Remove lint from the blower housing and internal ducts.
Check thermal fuse and thermostats: Access the rear panel and locate the thermal fuse and thermostats on the blower housing or heater duct. Test for continuity with a multimeter. Replace any open components.
Test dryer heater: Measure resistance across the dryer heating element. Replace if open or shorted to ground.

Hard 4/5

Dryer Heating Element

Check Price on Amazon

We may earn a commission from links on this page.